Hello,
Next were doors and door rails. The with brass stripes reinforced door rails were quite stable.
I measured the distance between sidewall and door how much space is there between.It was 0.8mm here and i cut some 0.8mm styrene sheet to fit into the door space.
So the thin door castings were glued full faced and will have no chance to warp anymore.
Note: Here the doors are those areas where you will grab the car inevitable with your 5-finger crane to handle it.
The straightened and reinforced door rails were then an easy task to mount.
Lutz
Next were doors and door rails. The with brass stripes reinforced door rails were quite stable.
I measured the distance between sidewall and door how much space is there between.It was 0.8mm here and i cut some 0.8mm styrene sheet to fit into the door space.
So the thin door castings were glued full faced and will have no chance to warp anymore.
Note: Here the doors are those areas where you will grab the car inevitable with your 5-finger crane to handle it.
The straightened and reinforced door rails were then an easy task to mount.
Lutz