08-21-2020, 03:55 AM
Hello,
The next step were the steps. Here the base are parts from A-Line. As they will be mounted from the side, the upper parts were bend 90°.
After mounting i formed the lower steps out of the brass stripe in the kit. Soldering is the only solution here at this exposed place.
The completed undercarriage. Small pieces of styrene were glued into the gaps between truck bolsters and couple boxes to close them.
Mounting the roof. Overnight cure for the glue.
Lutz
The next step were the steps. Here the base are parts from A-Line. As they will be mounted from the side, the upper parts were bend 90°.
After mounting i formed the lower steps out of the brass stripe in the kit. Soldering is the only solution here at this exposed place.
The completed undercarriage. Small pieces of styrene were glued into the gaps between truck bolsters and couple boxes to close them.
Mounting the roof. Overnight cure for the glue.
Lutz