01-11-2009, 12:10 PM
This might be a little late to do you any good but I will give you some info. anyway.
First--- Get the wife ( CEO of the railroad) a new hair drier. Get a better one than the one that smoked.
Next try this embossing heat tool. It is a lot smaller than any thing that I have seen. I use one all most every day when doing DCC installs.
Works great on heat shrink. Does not blow hot air all over the place. The embossing tool can be found at your local Michales store.
Here is a link for it. BTW it is a Marvy Model 2500 <!-- m --><a class="postlink" href="http://www.uchida.com">http://www.uchida.com</a><!-- m -->
http://www.uchida.com
Happy heating
First--- Get the wife ( CEO of the railroad) a new hair drier. Get a better one than the one that smoked.
Next try this embossing heat tool. It is a lot smaller than any thing that I have seen. I use one all most every day when doing DCC installs.
Works great on heat shrink. Does not blow hot air all over the place. The embossing tool can be found at your local Michales store.
Here is a link for it. BTW it is a Marvy Model 2500 <!-- m --><a class="postlink" href="http://www.uchida.com">http://www.uchida.com</a><!-- m -->
http://www.uchida.com
Happy heating