Walthers 90' Turntable - Printable Version +- (https://bigbluetrains.com) +-- Forum: The Back Shop (https://bigbluetrains.com/forumdisplay.php?fid=52) +--- Forum: DCC (https://bigbluetrains.com/forumdisplay.php?fid=38) +--- Thread: Walthers 90' Turntable (/showthread.php?tid=4100)

Walthers 90' Turntable - upnick - 06-10-2011 Hi All, This week i recieved a Walthers 90ft turntable & motor 933-3171 from Maders trains for a new end to end layout as below it will possibly have some more tracks to it but the turntable will be as is, my question is how do i wire it for DCC from what i have read it isnt the split ring type to auto change polarity. With this in mind i presume an autoreverser will be needed i have in mind the DCC specialities PSX-AR suitable for use with an NCE powercab unlike the cheaper one from them ........... using the diagram below can anyone mark where the track feeds & insulating breaks need to be please Re: Walthers 90' Turntable - rrinker - 06-10-2011 You shouldn't need any insulated gaps, just wire the two wires from the turntable that are the bridge track power to the output of the autoreverser. --Randy Re: Walthers 90' Turntable - Steamtrains - 06-10-2011 The "in" power can come from any of the approach tracks....Just make sure that all the storage tracks are wired the same as the approach tracks. I used SPST switches to turn the storage tracks on or off. That way I don't have my decoders "hot" all the time. With that turntable make sure you "fine tune" it as much as possible, The bridge tends to have a lot of "slop", both horizontally and vertically. I had to uninstall mine and get it as close to "good" as I could, but I'm stll pondering whether to get rid of it and put in a "real" one...