05-19-2014, 02:32 PM
First attempt of use of rivet strips on my small brass gondolas.
![[Image: niet-streifen_test-01kk.jpg]](http://us-modelsof1900.de/wp-content/gallery/niet-streifen/niet-streifen_test-01kk.jpg)
The upper strip is made from 0.005 styrene, the lower from 0.01 (0,25 mm), in both cases 0.080 wide.
I think that I should use the thinner strips however the position of rivets must be placed similarly to lower angle.
In any case, the new angles must cover the old ones which have been etched into the walls only.
The upper strip is made from 0.005 styrene, the lower from 0.01 (0,25 mm), in both cases 0.080 wide.
I think that I should use the thinner strips however the position of rivets must be placed similarly to lower angle.
In any case, the new angles must cover the old ones which have been etched into the walls only.
Cheers, Bernd
Please visit also my website www.us-modelsof1900.de.
You can read some more about my model projects and interests in my chronicle of facebook.
Please visit also my website www.us-modelsof1900.de.
You can read some more about my model projects and interests in my chronicle of facebook.