07-14-2014, 01:43 PM
Well, got the wound vac dressing changed and it's behaving itself for now.
Van engine started up fine this morning and with only minimal priming. It didn't try stalling out either as it sometimes does for seemingly no reason. Maybe it's gotten wind that it's about to be cast adrift and replaced.
Thanks to RT the IIc has it's sound back. The speaker was just a hair to big for the opening it needed to fit. So I brought out the Dremel and made a few little changes in the speaker bay and it slipped right in. There was some danger of the back of the speaker touching the keyboard circuit board so I put a piece of electrical tape over that part of the speaker. Closed up the unit and tested it and it works fine.
Van engine started up fine this morning and with only minimal priming. It didn't try stalling out either as it sometimes does for seemingly no reason. Maybe it's gotten wind that it's about to be cast adrift and replaced.
Thanks to RT the IIc has it's sound back. The speaker was just a hair to big for the opening it needed to fit. So I brought out the Dremel and made a few little changes in the speaker bay and it slipped right in. There was some danger of the back of the speaker touching the keyboard circuit board so I put a piece of electrical tape over that part of the speaker. Closed up the unit and tested it and it works fine.
15 year veteran fire fighter
Collector of Apple //e's
Beatus homo qui invenit sapientiam
Collector of Apple //e's
Beatus homo qui invenit sapientiam