12-23-2014, 01:36 PM
On the wheel sets I bought there is a square bearing support and the side frames on my diesels have a slot that the end of the axles slip into. the only thing
I had to do was to make sure that the bearing blocks were square so they would slide into place. A pair of tweezers helps.
If you are in doubt check with Athearn,help@athearn.com. At their site under I believe trucks and accessories or parts they show two different sets of nickle silver wheel sets.
40" and 42". Each set comes packages in sets of 6. I also found the 40" wheel sets on ebay. In the search area type in parts and under category make sure it says Athearn.
Hope this help
I had to do was to make sure that the bearing blocks were square so they would slide into place. A pair of tweezers helps.
If you are in doubt check with Athearn,help@athearn.com. At their site under I believe trucks and accessories or parts they show two different sets of nickle silver wheel sets.
40" and 42". Each set comes packages in sets of 6. I also found the 40" wheel sets on ebay. In the search area type in parts and under category make sure it says Athearn.
Hope this help
"My railroad is a figment of my imagination"
BobS
BobS