02-10-2015, 08:55 AM
I had the same mishap. It was quite easy to repair with styrene as you plan to do it.
I used two pieces of styrene. A thicker one and a very thin one on top overlapping with the upper part. That saved the putty and ensure a perfect surface.
This is a pilot plate of the prototype that looks like the one I built with two pieces of styrene
http://www.railpictures.net/viewphoto.ph...770&nseq=8
I used two pieces of styrene. A thicker one and a very thin one on top overlapping with the upper part. That saved the putty and ensure a perfect surface.
This is a pilot plate of the prototype that looks like the one I built with two pieces of styrene
http://www.railpictures.net/viewphoto.ph...770&nseq=8
Reinhard