09-16-2015, 10:42 PM
If only didn't cost $250 to print a passenger car body shell, then I might enjoy 3D printing a little more.
The one thing i would like to make is replacement bushings for the new proto Amfleet cars. The metal ones kinda grind and slow the cars down, while I understand that the black or white strong and flexible is very slippery against metal axles (was was demonstrated on a 3D model with trucks printed in that material). Just gotta make a square with a hole in it, easy enough!
The one thing i would like to make is replacement bushings for the new proto Amfleet cars. The metal ones kinda grind and slow the cars down, while I understand that the black or white strong and flexible is very slippery against metal axles (was was demonstrated on a 3D model with trucks printed in that material). Just gotta make a square with a hole in it, easy enough!
Modeling New Jersey Under the Wire 1978-1979.
![[Image: logosmall.png]](http://i543.photobucket.com/albums/gg445/CAB_IV/Model%20Trains%202013/logosmall.png)