DPM Scissor's cutting kitbash

[cnrglen]

I pulled out the razor saw and sliced up the walls to my structure tonight:

I have noticed that the walls that I cut off had the brickwork wrapping around the end so I'll either have to carve the bricks back in or cover the now blank styrene somehow.

I took off two small strips on the top and bottom of the short end walls to make them match up with the tall end wall. I just have to splice them together now.

Now I was considering just covering the three dock doors with the brick sheet overlay but it's a bit too thick to look right. I can cut and remove that section and replace it with the brick sheet. I'm leaning toward that solution.