06-22-2017, 07:18 AM
If you want to make brewery, I would take the scale and grain silo track and make that inbound side with a spot each for bottles, cans and packaging.
I would extend the brewery spur parallel to the shipping/receiving spur and put a loading dock between them as the beer loading area, RBL's on one track, reefers and overflow RBL's on the other.
I would extend the service track and make it two tracks in the power house area and make that the grain unloading area. One spot for hops, another for grain.
I would lose the engine house and power plant. Unless you are modeling 1920, they aren't going to have a coal fired brewery.
Since the loading tracks are most likely covered (inside the building, you could swap the sides with the loading tracks and the grain tracks and have the loading tracks along the front edge where you can see inside the building.
I would extend the brewery spur parallel to the shipping/receiving spur and put a loading dock between them as the beer loading area, RBL's on one track, reefers and overflow RBL's on the other.
I would extend the service track and make it two tracks in the power house area and make that the grain unloading area. One spot for hops, another for grain.
I would lose the engine house and power plant. Unless you are modeling 1920, they aren't going to have a coal fired brewery.
Since the loading tracks are most likely covered (inside the building, you could swap the sides with the loading tracks and the grain tracks and have the loading tracks along the front edge where you can see inside the building.