Back to trains......or should I say trestle.
I really was hoping to get some painting done on a certain item (
The Crane
) but I paint outside and it started to rain as I was about to get started
So, I worked on the trestle instead.
First I drew the deck out on my work surface and then started cutting, fitting, and gluing:
![[Image: Cst6Si.jpg]](https://i.vgy.me/Cst6Si.jpg)
The two center-most beams are the stringers that will be directly below the rails:
![[Image: eWYDXA.jpg]](https://i.vgy.me/eWYDXA.jpg)
A quick test fit of the track:
![[Image: PoKg1M.jpg]](https://i.vgy.me/PoKg1M.jpg)
Here I have removed the center portions of about every other tie:
![[Image: ddgoKx.jpg]](https://i.vgy.me/ddgoKx.jpg)
Start of the weathering process (ink wash and a little chalk):
![[Image: 81Esrw.jpg]](https://i.vgy.me/81Esrw.jpg)
The next step is to start cutting the planking for the walkways on either side of the rails. This will be board by board again....oh joy!
Take care
I really was hoping to get some painting done on a certain item (
The Crane
) but I paint outside and it started to rain as I was about to get started
So, I worked on the trestle instead.
First I drew the deck out on my work surface and then started cutting, fitting, and gluing:
![[Image: Cst6Si.jpg]](https://i.vgy.me/Cst6Si.jpg)
The two center-most beams are the stringers that will be directly below the rails:
![[Image: eWYDXA.jpg]](https://i.vgy.me/eWYDXA.jpg)
A quick test fit of the track:
![[Image: PoKg1M.jpg]](https://i.vgy.me/PoKg1M.jpg)
Here I have removed the center portions of about every other tie:
![[Image: ddgoKx.jpg]](https://i.vgy.me/ddgoKx.jpg)
Start of the weathering process (ink wash and a little chalk):
![[Image: 81Esrw.jpg]](https://i.vgy.me/81Esrw.jpg)
The next step is to start cutting the planking for the walkways on either side of the rails. This will be board by board again....oh joy!
Take care
Steve
