04-17-2026, 09:54 PM
Work continues on the engine facility. Over the past couple of days I have been busy getting the floor put down. There is only a small section left to do and that will happen this weekend. Below is what I have done so far. I think it turned out ok in my opinion. Does anyone have any photo's of inside of their engine facility to give me some guidance with oil, grease stains and other stains that are famous for being on the floor? I am also happy with the height of the doors for the locomotives to enter and exit.
Also you will notice natural cracking. I didn't add any detail to the floor as it appeared once it dried completely. That was another thing that was on my mind that just naturally happened lol.
Also you will notice natural cracking. I didn't add any detail to the floor as it appeared once it dried completely. That was another thing that was on my mind that just naturally happened lol.
Matt
Conrail's Blairsville Cutoff - A Fictitious Alternative Route Over The Allegheny Mountains From Blairsville, Pa to Cresson, Pa
Milepost 296.0 to Milepost 250.0