06-28-2009, 07:35 PM
Thanks Nachoman, if there has been anything here that can help your modeling, I'm very glad!
Steve, I know a bit about Maywood, you probably aren't far from the NYS&W main, and the nice station on (I think) Maywood Ave.
Gus, I'll see what I can do to get some more pics of that Hudson.
Thanks 88, I like to add details like the guy lowering the door. I know what you mean by a bridge of sorts to carry the pipe, but thet isn't the look I'm going for. I've attached some pics here to show whatI've had in mind, should have posted them earlier.
Thanks Wayne, see what you think about the pics below.
Pete, you put into words what my concern was about putting in a support beneath the elbow, I would think two supports, one on either side of the elbow, would be the way to go. Unless there did not need to be any, since the elboe is close to the powerhouse wall. Perhaps one in the center of the run as Wayne suggested.
I love the photo of the lamp in the cabin cruiser! And, it looks like a party I wish I had been invited to!
I'd appreciate anyones and everyones thoughts on the placement of supports per the below pics. The parts in the pics are Plastruct parts, made for that diameter pipe. A pole of some sort, either tubing or square stock would run to the ground, perhaps be encased in concrete. The prototype pic, an enlargement of part of one of the pics I posted earlier, show the pipe I am modeling. Bit I'm darned if I can tell which upright is a support for the pipe! You've got the water column, a pole that has lights mounted on it, etc. Depth of field is such I can't be certain what is in front of the pipe. But between the two pics, perhaps someone can hazard a good guess. Thanks!
Steve, I know a bit about Maywood, you probably aren't far from the NYS&W main, and the nice station on (I think) Maywood Ave.
Gus, I'll see what I can do to get some more pics of that Hudson.
Thanks 88, I like to add details like the guy lowering the door. I know what you mean by a bridge of sorts to carry the pipe, but thet isn't the look I'm going for. I've attached some pics here to show whatI've had in mind, should have posted them earlier.
Thanks Wayne, see what you think about the pics below.
Pete, you put into words what my concern was about putting in a support beneath the elbow, I would think two supports, one on either side of the elbow, would be the way to go. Unless there did not need to be any, since the elboe is close to the powerhouse wall. Perhaps one in the center of the run as Wayne suggested.
I love the photo of the lamp in the cabin cruiser! And, it looks like a party I wish I had been invited to!
I'd appreciate anyones and everyones thoughts on the placement of supports per the below pics. The parts in the pics are Plastruct parts, made for that diameter pipe. A pole of some sort, either tubing or square stock would run to the ground, perhaps be encased in concrete. The prototype pic, an enlargement of part of one of the pics I posted earlier, show the pipe I am modeling. Bit I'm darned if I can tell which upright is a support for the pipe! You've got the water column, a pole that has lights mounted on it, etc. Depth of field is such I can't be certain what is in front of the pipe. But between the two pics, perhaps someone can hazard a good guess. Thanks!