06-10-2010, 12:50 PM
Gary,
The progress looks good!
I'm using Atlas custom line turnouts as well, and I hope I don't have any issues with those! I haven't take a close look at them just yet to see if any are likewise warped.
But then again I've hand-laid some turnouts (5 to be exact) and only plan to lay one by hand on the present layout (if I have to, I guess). Still, that experience goes a long way towards correcting errors in ready made products. At least I hope it will, again, if it's necessary. We'll see.
Galen
The progress looks good!
I'm using Atlas custom line turnouts as well, and I hope I don't have any issues with those! I haven't take a close look at them just yet to see if any are likewise warped.
But then again I've hand-laid some turnouts (5 to be exact) and only plan to lay one by hand on the present layout (if I have to, I guess). Still, that experience goes a long way towards correcting errors in ready made products. At least I hope it will, again, if it's necessary. We'll see.
Galen
I may not be a rivet counter, but I sure do like rivets!