12-15-2010, 01:01 PM
You've got that right, Russ. I bought some Walthers drill bits because the LHS was out of the sizes I needed in my usual Maxon bits. While they worked well enough to finish the job on which I was working, they were flexible enough to drill around corners, 
and they didn't stay sharp for long. I also found hobby-sized bits (and numbered ones right up to #1) at a local tool supply store - prices were comparable to those at the hobby shop, but cheaper if you bought a 10-pack of one size. They're of good quality, too, and will cut dozens of holes if I don't snap them off. 
Wayne
and they didn't stay sharp for long. I also found hobby-sized bits (and numbered ones right up to #1) at a local tool supply store - prices were comparable to those at the hobby shop, but cheaper if you bought a 10-pack of one size. They're of good quality, too, and will cut dozens of holes if I don't snap them off. Wayne