02-06-2011, 04:11 PM
Koos,
thank you very much for your link. However there is the problem that these drill bits do not have an oversized shank. I have to tried using my drill bits with a pin vise however than I developed to many power for a smooth drilling. On this way two of my 0.2 mm drill bits were broken and so I use them turning by two figers only until a new challenge will come. I think that you will not have a good handling without such oversized shanks.
Thanks anyway!
thank you very much for your link. However there is the problem that these drill bits do not have an oversized shank. I have to tried using my drill bits with a pin vise however than I developed to many power for a smooth drilling. On this way two of my 0.2 mm drill bits were broken and so I use them turning by two figers only until a new challenge will come. I think that you will not have a good handling without such oversized shanks.
Thanks anyway!
Cheers, Bernd
Please visit also my website www.us-modelsof1900.de.
You can read some more about my model projects and interests in my chronicle of facebook.
Please visit also my website www.us-modelsof1900.de.
You can read some more about my model projects and interests in my chronicle of facebook.