05-13-2011, 08:04 AM
The only time I have encountered this problem is if I've had too much rail sticking out of the groove when filing the points. Typically, I make sure that the edge of the rail head closest to tool just barely exits the opening where the rail sticks out. This eliminates excess material sticking out and a lot of filing.
Cutting an angle in the rail is a new one though. I'll have to try it as the club has enlisted me to construct another Cd 100 three way for our staging yard.
Cutting an angle in the rail is a new one though. I'll have to try it as the club has enlisted me to construct another Cd 100 three way for our staging yard.