08-09-2011, 03:48 PM
The air tank mounting tabs were bent down as shown.
The holes were drilled and the air tank mounts were filed.
The assembly was then centered, clamped in place and soldered.
Here's a photo of the project so far.
The fuel tank will be next.
The motor is marked "Kader 881" , so I assumed it was a Bachmann.
These are the dimentions for the fuel tank.
The holes were drilled and the air tank mounts were filed.
The assembly was then centered, clamped in place and soldered.
Here's a photo of the project so far.
The fuel tank will be next.
The motor is marked "Kader 881" , so I assumed it was a Bachmann.
These are the dimentions for the fuel tank.
Ray Marinaccio