01-21-2012, 10:51 AM
Mark – I’m a little to the thread but thanks for posting the updates. I’m not sure how much relief you are looking for but I can picture most of your scene as “street running” through the complex. I can’t see any place that you can something other than maybe a small drainage ditch. You could use any of those products you mentioned. HO cork will limit you to 1/8” in depth. You could look at some foam core board (Gator Board) up to say ½”. I haven’t used Homastoe or ceiling tile so I can’t help you there but I would also consider what is easiest and reasonable (price wise) to get.
A couple of questions for you if you don’t mind since you basically mocked up a couple of areas I’m working on now.
In the beginning you said this was 18” x 96” but then said 20+”, so I can figure how it will work for me, what is the width as pictured above?
About how long is the large main building flat? And the bump out portion of that building next to the water tower?
Thanks for sharing the layout
Steve
A couple of questions for you if you don’t mind since you basically mocked up a couple of areas I’m working on now.
In the beginning you said this was 18” x 96” but then said 20+”, so I can figure how it will work for me, what is the width as pictured above?
About how long is the large main building flat? And the bump out portion of that building next to the water tower?
Thanks for sharing the layout
Steve
Modleing the Jefferson Branch in HO on the Southern Pacific