Lets build a camelback,, or two.

[e-paw]

As you can see in this pic I ran into a little trouble... I didn't use enough mold release and the 2 halves of the molds fused together. One mold survived enough to be usable, but the other 2 will need to be recast.    

So back to the workbench to make some new molds.    

well here's the first run,     not bad for a first try. The still have some flash on then and the backhead casting is kind of thin, but it's a first try & I'm learning as I go. I'm going to cast at least 4 sets & pick the best ones for this project before I continue with the build.