05-25-2012, 07:08 AM
I just picked up a Proxxon FET micro table saw and wondered if anyone here has one or has had experience with one?;
http://www.proxxontools.com/store/pc/vie...roduct=196
http://www.amazon.com/Proxxon-37070-FET-...roduct_top
The older version had a speed control that the newer model does not. According to the instructions for that model, slower speeds were better for plastics, which is what I bought this for. I didn't know this model had no control and was somewhat disappointed.
I did a little search and found one Italian model forum where one member stated that table saws should be run at full speed which surprised me. Anyone have any comment to this?
http://www.proxxontools.com/store/pc/vie...roduct=196
http://www.amazon.com/Proxxon-37070-FET-...roduct_top
The older version had a speed control that the newer model does not. According to the instructions for that model, slower speeds were better for plastics, which is what I bought this for. I didn't know this model had no control and was somewhat disappointed.
I did a little search and found one Italian model forum where one member stated that table saws should be run at full speed which surprised me. Anyone have any comment to this?