07-22-2012, 11:35 PM
:hey: [b]Hello all, does anyone on the gauge repair engines, I bought an Athearn 4-6-6-4 Challenger new a few years ago, and it is my favorite engine, I ran it whenever I was able to get down to my basement, a couple of years my grandson was visiting, and he ran it too fast coming into a curve, and it jumped the track and dropped about 30 inches to the concrete floor, a couple of trim pieces were broken, and one of the wires broke off of the wire harness, I wrote a letter and boxed it up and sent it to Athearn, and advised them to make the repairs and notify me of the charges, approximately 6 weeks later it was returned with a hand written note saying it was repaired at no charge. At the time I had recently had a heart attack and was unable to run it for a few months, anyway when I finally put it on the track, it causes my MRC DCC system to short out, I am hoping to find someone on the gauge that has the ability to repair it, if the cost is not prohibitively high, Hopping to hear from someone with the ability, :cry: please advise...
Please PM for contact information.
Please PM for contact information.