Building the Walthers N Blast Furnace ~~ Start to Finish

[Trucklover]

I glued the supports for the Mantle Ring to the Ring and then to the wall of the Furnace.



Step 7
Was to glue the supports for the Bell Platform to the Platform and the Furnace



Step 8
Glued the Bell Hopper to the top of the Furnace.



Step 9
I glued the Trolley Supports to the Bell Platform. I noticed that the Beam Bells were in the wrong spot because the Trolley Supports would not fit because of the location of the Bell Hopper. I moved the Beam Bells to the right loccation which is right next to the Sheaves and Sheave rod.



Step 10
I then put the top of the furnace together. I glued the Bleeder Platform to the tops of the Offtakes. Then the Bleeder Valves and Bleeder Handles were added on top of the Bleeder Platform. Next, the handrails were added around the Platform and was finished off by glueing the Platform Bracing to the top.