11-28-2012, 09:07 PM
Rob: you may have to use the cutters twice, once in each direction, to both get a smooth cut on both faces and to have a bit of a gap.
You will probably want to file the running surfaces afterwards, anyway.
Don't use them on anything other than rails or small copper wire. Guitar strings, switch machine rods will notch the blades.
You will probably want to file the running surfaces afterwards, anyway.
Don't use them on anything other than rails or small copper wire. Guitar strings, switch machine rods will notch the blades.
David
Moderato ma non troppo
Perth & Exeter Railway Company
Esquesing & Chinguacousy Radial Railway
In model railroading, there are between six and two hundred ways of performing a given task.
Most modellers can get two of them to work.
Moderato ma non troppo
Perth & Exeter Railway Company
Esquesing & Chinguacousy Radial Railway
In model railroading, there are between six and two hundred ways of performing a given task.
Most modellers can get two of them to work.