02-14-2009, 11:00 AM
A little bit more done this morning.
I cut a rectangular opening on one side panel for the device box, and drilled a 3/8 hole on the panel for the other side to accommodate the tool cord.
![[Image: DSC02823.jpg]](http://i229.photobucket.com/albums/ee118/tetters73/DSC02823.jpg)
![[Image: DSC02825.jpg]](http://i229.photobucket.com/albums/ee118/tetters73/DSC02825.jpg)
I then installed the device box and switch on the one side and threaded the cord through the other side.
![[Image: DSC02824.jpg]](http://i229.photobucket.com/albums/ee118/tetters73/DSC02824.jpg)
![[Image: DSC02826.jpg]](http://i229.photobucket.com/albums/ee118/tetters73/DSC02826.jpg)
I then put the sides on and re-tested my wiring.
![[Image: DSC02827.jpg]](http://i229.photobucket.com/albums/ee118/tetters73/DSC02827.jpg)
![[Image: DSC02829.jpg]](http://i229.photobucket.com/albums/ee118/tetters73/DSC02829.jpg)
![[Image: DSC02828.jpg]](http://i229.photobucket.com/albums/ee118/tetters73/DSC02828.jpg)
![[Image: DSC02830.jpg]](http://i229.photobucket.com/albums/ee118/tetters73/DSC02830.jpg)
Tonight, I'll begin to glue and assemble the pieces permanently. One obstacle I need to figure out is how to connect the exhaust vent to the station. I have a couple of ideas, I'm just trying to figure out what will be the best solution.
I cut a rectangular opening on one side panel for the device box, and drilled a 3/8 hole on the panel for the other side to accommodate the tool cord.
I then installed the device box and switch on the one side and threaded the cord through the other side.
I then put the sides on and re-tested my wiring.
Tonight, I'll begin to glue and assemble the pieces permanently. One obstacle I need to figure out is how to connect the exhaust vent to the station. I have a couple of ideas, I'm just trying to figure out what will be the best solution.