12-28-2009, 06:18 PM
One of my throttles has a problem that I have been unable to address. Namely when I plug it into a UP5 loconet and then put on track power the following occurs on this one throttle: the viewing screen intermittently flashes 'dt300id' then it flashes track voltage, back and forth it goes! I have no control of the throttle at this point for any function. When it is flashing the track voltage the semiphore signal indicators also flash in the corner of the screen and a series of numbers scroll across the top of the screen also!!! All very confusing. Just in case the loconet plug was worn I replaced it but it is the same. Any suggestions other then sending it to Digitrax for a fix?
Thx
Eric
Thx
Eric