03-21-2010, 06:12 PM
Using some washes of the same colors I weathered the under frames.
While that dried I started on the window glazing.
Instead of using some clear plastic I applied a bead of Testors Clear Parts Cement around each window opening on one end of the car. Then using the applicator tip I pulled it into the center of the window in a circular motion until the whole window had a thin film of cement across it. when it dries it will be perfectly clear.
While that dried I started on the window glazing.
Instead of using some clear plastic I applied a bead of Testors Clear Parts Cement around each window opening on one end of the car. Then using the applicator tip I pulled it into the center of the window in a circular motion until the whole window had a thin film of cement across it. when it dries it will be perfectly clear.
My other car is a locomotive, ARHS restoration crew