11-10-2010, 10:13 PM
Pretty sure the magic wand will work on DCC track as well. The trick is to actually find the right spot - on Broadway Limited steam locos with the wand I found it easier to take off the tender shell so I could see where the reed switch was and orient the magnet so that it truly closed. The trick with the reset on QSI decoders is after you use the wand you must REMOVE POWER FROM THE LOCO - just tilt it up on one side for a second, and the set it back down to complete the reset process.
However - you may have it in one of the shutdown modes. Do a double press of F6 to get it to start up - see of that's all it is.
Interesting, the Atlas instructiosn say definitely DC to use the wand, that's somewhat contrary to the original QSI instructions.
--Randy
However - you may have it in one of the shutdown modes. Do a double press of F6 to get it to start up - see of that's all it is.
Interesting, the Atlas instructiosn say definitely DC to use the wand, that's somewhat contrary to the original QSI instructions.
--Randy
Modeling the Reading Railroad of the 1950's in HO
Visit my web site to see layout progress and other information:
http://www.readingeastpenn.com
Visit my web site to see layout progress and other information:
http://www.readingeastpenn.com