08-30-2010, 07:07 PM
woodone Wrote:There are a lots of CV's to work with on a Tsunami. You should set up the decoder so it will sound like a Articulated engine. Does the loco have dual air pumps or a single as that can ge set also by changing the CV value in CV 112, There is also a CV for chaning the slip rate on the Articulated loco's. CV116 will set the chuff rate.
There are so many CV's on a Tsunami your best friend is to use Decoder-Pro. Will make setting up a locomotive much faster.
Looks like in the video you are having some problem with the loco shutting down at times. Try add a much larger capacitor to the decoder.
Replace the 220 Uf capacitor with a 2200 Uf capacitor. You might want to look at using resistor- diode circuit to limit the inrush current if there are lots of sound units on the layout too.
looks like The 2200uf capacitor is going to be a must also the resistor-diode circuit as there are getting to be quite a number of sound equipped engines on our layout....as to the cap.they come in several different varietys,2200 Uf 16v.... 2200 Uf 25v etc. i would assume the 2200uf 25v is the one i would want,not being a electrical wizard do that sound about right
Did get around to changing some of the sound settings,volume, articulation , rod clank and such,kinda blew though and forgot to checkout the steamboat whistle that would be more appropreate for this engine,right now its set for Frisco 1522.....next time! sound a little better?
<!-- m --><a class="postlink" href="http://www.youtube.com/watch?v=27hmJcs1vWQ">http://www.youtube.com/watch?v=27hmJcs1vWQ</a><!-- m -->