09-23-2010, 02:39 PM
Tetters,
Are you using Decoder- Pro? I don't recall if you are.
Tsunami's do not support CV5 or 6
For slow speed operation you need to set the CV's 2,3 and 4 to zero. Then find CV209 and 210, if you have not changed them they should be 25 and 20.
Set CV210 first- set to about 10 or so. now run the loco at speed step 1. You want to set 210 so the loco just moves (it will be jerky) so you may have to play with the CV210 a bit. Now go to CV209 and try to smooth it out by changing CV209. You might have to go back and change CV210 again too.
It will take a while to get it just right for you.
Hope that you are using Decoder-Pro as it is much faster to work with when you are doing this.
You can also set the speed tables to fit your needs also.
Are you using Decoder- Pro? I don't recall if you are.
Tsunami's do not support CV5 or 6
For slow speed operation you need to set the CV's 2,3 and 4 to zero. Then find CV209 and 210, if you have not changed them they should be 25 and 20.
Set CV210 first- set to about 10 or so. now run the loco at speed step 1. You want to set 210 so the loco just moves (it will be jerky) so you may have to play with the CV210 a bit. Now go to CV209 and try to smooth it out by changing CV209. You might have to go back and change CV210 again too.
It will take a while to get it just right for you.
Hope that you are using Decoder-Pro as it is much faster to work with when you are doing this.
You can also set the speed tables to fit your needs also.