12-15-2012, 06:59 PM
Thats the way it starts, the next step is to change the locomotive address and the start voltage. You want the locomotive to just barely move at speed step 1.
I start with a value of 45 for start voltage, if it still doesn't move at speed step one, go higher in steps of 10, if it goes to fast go the other way in steps of 10, then fine tune when you get close.
Charlie
I start with a value of 45 for start voltage, if it still doesn't move at speed step one, go higher in steps of 10, if it goes to fast go the other way in steps of 10, then fine tune when you get close.
Charlie