01-12-2013, 12:01 PM
I tried the procedure Charlie recommended, on both the main and the programming track. Programming on the main doesn't seem to work at all -- I need to do a "select loco", and I don't seem to be able to pick up the loco even at short address 3. If I do it on the programming track, I can program the CVs on the loco that's on the track, irrespective of address. The loco makes a little shake when I program each CV, but when I'm done, I have the same old result, I can't select the loco at either long address 108 or short address 3. When I reset the CV 8 to 8, it picks up the loco again and works as specified. I'm not completely sure if the loco is responding to an actual short address 3 or if it's just the default loco on the track at that point, though.