03-02-2013, 01:06 PM
Puddle jumper,
That is a thought I had as I think once you have your design you can scale it up or down with in the limits of the build area. I have to get proficient with with the software before doing anything for others.
I have to get the printer first and then find my way around the software. A lazy round about way would be to scratch build some master parts and then 3D scan them but that takes some $$$$ to set up my computer or even more $$$$ to get the system like the one made by next engine.
My vision is to make trucks, wheelsets?, car sides, end parts, doors, hatches, roof and underside/chassies. And as you asked I can most likely scale them up or down as needed but that is way down the line from now.
Will keep this thread updated often.
That is a thought I had as I think once you have your design you can scale it up or down with in the limits of the build area. I have to get proficient with with the software before doing anything for others.
I have to get the printer first and then find my way around the software. A lazy round about way would be to scratch build some master parts and then 3D scan them but that takes some $$$$ to set up my computer or even more $$$$ to get the system like the one made by next engine.
My vision is to make trucks, wheelsets?, car sides, end parts, doors, hatches, roof and underside/chassies. And as you asked I can most likely scale them up or down as needed but that is way down the line from now.
Will keep this thread updated often.