Sweet sound
#16
Well the problem with the ESU decoders (both with and without sound) is the humming sound at low speed. That sound will not be noticed at meetings, exhibitions and operating sessions with several peoples. You will notice it switching directly in front of you on a small ISL in a very silent environment (e.g. layout room at night).

Tsunami can do a smooth start if you
1. Set CV 66 and 95 to values below 50
2. Set CV 209 to 50 - 100
3. Set CV 210 to 5 -10
4. Set custom speed table in CV 25 and 29
5. Start the speed table CV 67 - 95 with 1,2,3... increase the steps to 3, 4, 5, 10 and finally 20. The end value should be around 175.

My preferred table is:
1 2 3 6 9 12 15 18 21 24 27 30 33 37 41 45 49 53 57 62 67 77 87 107 127 137 157 177
Reinhard
Reply


Messages In This Thread

Forum Jump:


Users browsing this thread: 1 Guest(s)