07-09-2018, 06:29 PM
There has been some progress on the brewery.
Content of the kit.
Some of the tools I use.
I started by measuring the parts and identifying them with the numbers from the manual.
I add woodgrain with a wire brush.
I cut out the windows with a xacto chisel blade, then I stained the areas which were to be glued together.
I add nail holes with a Trumpeter rivet wheel.
As you see, the wall lines up on the right side and the left is offset.
After staining the walls with india ink and alcohol, I paint the peeled off paint.
I use turps on a brush and while the surface is wet, I apply the acrylic paint which then pearls up in places to look like peeled off paint when dry.
I used a light grey green paint.
Painted walls.
Content of the kit.
Some of the tools I use.
I started by measuring the parts and identifying them with the numbers from the manual.
I add woodgrain with a wire brush.
I cut out the windows with a xacto chisel blade, then I stained the areas which were to be glued together.
I add nail holes with a Trumpeter rivet wheel.
As you see, the wall lines up on the right side and the left is offset.
After staining the walls with india ink and alcohol, I paint the peeled off paint.
I use turps on a brush and while the surface is wet, I apply the acrylic paint which then pearls up in places to look like peeled off paint when dry.
I used a light grey green paint.
Painted walls.