01-02-2019, 12:45 PM
(01-01-2019, 08:51 PM)Charlie B Wrote: If all the others run fine I would put them on the program track and do a complete reset. Be sure to remove the locomotive from all power for the reset to complete. I assume you have never had them consisted, but if you have you might want to try setting CV 19 to 0 before trying the reset. Remember the locomotive will respond to the address 3 after a reset. The instructions for the locomotives should give the settings for a reset. Sometimes it works better on the main but make sure no other locomotives get reset if you have to do that.
Charlie
OK you have gone off the reservation with this!!! I'm Old and New at this DCC stuff! what is code CV19 and address 3? I have the NCE Power Cab. didn't see any reference to those codes in the book?
Thankyou for the help If you could just explain or simplify your Reply