01-24-2022, 12:06 AM
The next thing I decided to try for the first time is adding feeds to the track. I purchased some pre-soldered rail joiners to use. This is in anticipation of future DCC installation.
This is how I installed them.
I installed the rail joiners.
I used an awl to start a hole through the foam board.
Next I used a long screw driver to poke through.
I then inserted a Evergreen tube into the whole.
I inserted a section of the wire into the tube.
Next pull the tube and the wire through the hole.
The finished feed.
This is how I installed them.
I installed the rail joiners.
I used an awl to start a hole through the foam board.
Next I used a long screw driver to poke through.
I then inserted a Evergreen tube into the whole.
I inserted a section of the wire into the tube.
Next pull the tube and the wire through the hole.
The finished feed.
Tom
Silence is golden but Duct tape is silver
Ridley Keystone & Mountain Railroad
My Rail Images Gallery
Silence is golden but Duct tape is silver
Ridley Keystone & Mountain Railroad
My Rail Images Gallery