09-13-2019, 04:03 PM
Satisfied with the results of the color i found an online picture of a square wood engine to copy.
If I find it again, I'll post a link here.
So, I began by making the side walls (about 7-1/2 inches long)
Gluing them to a 1/4 X 1/4 inked piece of wood.
The left is the inside the right is the outside
If I find it again, I'll post a link here.
So, I began by making the side walls (about 7-1/2 inches long)
Gluing them to a 1/4 X 1/4 inked piece of wood.
The left is the inside the right is the outside
~~ Mikey KB3VBR (Admin)
~~ NARA Member # 75
~~ Baldwin Eddystone Unofficial Website
~~ I wonder what that would look like in 1:20.3???
~~ NARA Member # 75
~~ Baldwin Eddystone Unofficial Website
~~ I wonder what that would look like in 1:20.3???