05-02-2024, 10:10 PM
Taking a break from building the mine as it took a little bit to get the pieces bent so they fit. Below is the progress of the new engine house that will be located at Revloc, Pa. This engine house is the closest I have now found to the building in Revloc. I had taken rail apart and glued it down into he grooves. I did have to cut a couple pieces to make sure they extended the entire length of the building. I like how this Walthers kit came with extra pieces in case there was a screw up. I can now use those other pieces for another project and maybe template. Anyways below is my progress so far.
Rail laid and drying
Holes drilled for the light fixtures
Two walls put up
Third wall up
The front is on and taped for drying over night
Rough idea of what's going to sit inside the engine house
The front of the building will dry over night and then the roof will be glued on. But before I do that I am going to mess around with a few ideas of what to have on the inside as in, gears, extra traction motors, cabs, etc etc. Just a few small things.
Rail laid and drying
Holes drilled for the light fixtures
Two walls put up
Third wall up
The front is on and taped for drying over night
Rough idea of what's going to sit inside the engine house
The front of the building will dry over night and then the roof will be glued on. But before I do that I am going to mess around with a few ideas of what to have on the inside as in, gears, extra traction motors, cabs, etc etc. Just a few small things.
Matt
I can smell a steam post ten blocks away and when I do clear the tracks because the steam express will be hi ballin through
http://cambriaindiana.weebly.com/
I can smell a steam post ten blocks away and when I do clear the tracks because the steam express will be hi ballin through
http://cambriaindiana.weebly.com/