Juneco Two stall enginehouse

[cnrglen]

Well this past week was a case of two steps forward, one step back. 
I started by staining the inside walls using testors stainFX pine:

   

Then I started to install the window and doors. I found that they were a bit too new looking so I brushed a bit of thinned umber on the frames.

   

Then the problem started to show
Since I decided on the color combination I noticed that almost all the walls had a slight bow in them but when I stained the inside, the bow became more pronounced.

   

So to correct this I added some extra stringers to the length on the walls, weighting them down with a steel block, by cordless drill and my cordless impact. This time I used Weldbond glue to attach the stringers instead of the Aileen's Tacky glue.
   

   

When that was done the walls were flat again. I'll stain the stringers later when the walls go up to ensure that they don't warp again. 

   

With that I finished installing all the windows and doors.