Juneco Two stall enginehouse

[cnrglen]

I don't know if it would work that way, experimentation sounds like the way to go.

I got the walls up on both the enginehouse and the rear office.
   

I started with one side wall and rear wall. I used weldbond glue for this assembly as it needs to be fairly tough. I did have to notch the extra stringers that I used to straighten the side walls so they would mate with the ends.
   
   

When I glued the other side wall and the front wall on I used my calipers to make sure the two ends were 'square' or at least the same width.  

   

With the main building done, I put up the walls for the office. I'm trying to make everything as square as possible because the roof is designed to be removable and that would depend on the structure being as squarely built as possible.

     

   

That being said, I did find gaps and some flaws in the wall joints that needed to be fixed.

   

So I used some extra stripwood to fill. Some paint and it hides the 'flaws' like that were never there.

     

The final job was to paint the extra wall stringers and the gap filling stripwood.
Next I'll be building the roof trusses and the car-shop lean-to.