07-07-2016, 07:29 AM
Charlie B Wrote:Now place the locomotives on the main and turn on your hand held throttle. Make sure the respond to their address' . If they do Hit the "consist button once and "set" comes into the display. Hit the enter button once. Now enter a consist number (1-127 are the only numbers that will work) and press enter. now enter the number of the unit in the lead, lets use 1234 and press enter, now you can change the direction the locomotive will run by hitting the direction button. It should say FWD without changing it and if this is OK push "enter" Now "LOCO will flash so insert the second unit number here (4321) and set the direction as needed before hitting enter. If you are done adding engines just hit enter again and it will show a locomotive number on the throttle. This number will not be the consist. push the Loco key and when it flashes insert the consist number here. That is the number you will use to run the train.
I hope this helps. I had a hard time understanding it when I first started but it comes easy once you start.
Hope this helps
Charlie
Charlie I followed your instructions step by step, they worked fine as far as moving 2 engines, all other functions like horn headlight and bell do not work. I'm starting to think maybe it's my Mrc controller? I have one engine that won't respond at all when put into a consist but responds fine on its own.
